PVC SLEEVES,
plastic sleeves, SHRINK SLEEVES, sleeving, TAMPER SEALS, TAMPER EVIDENT BAND,
TAMPER EVIDENT LABELS AND SEALS, TAMPER PROOF SEALS, heat shrink
tubing, banding, SHRINK BANDS, shrink tube, pre-form, preforms, seal
security label, bags seal security, high security seals, evident security seal
tamper, plastic security seals, security seals, high security seals, evident
seal security tamper, plastic security seals
Infrared Heat Tunnels
BACK
HEAT SHRINKABLE SLEEVES CLEAR PVC TUBING IN ROLLS DOMED BAGS TAMPER EVIDENT LABELS AND SEALS SHRINK BANDS FOR CD STACKS
SHRINK WRAP FILM COMBO PACKS PRINTED PVC AND PET SLEEVES PREFORMS HEAT GUNSHELPFUL HINTS WITH SLEEVES (Disable POP UP Blockers to view these helpful hints)
HELPFUL HINTS WITH SLEEVES
(Disable POP UP Blockers to view these helpful hints)
HEAT SHRINKABLE SLEEVES
Clear PVC tubing in rolls
DOMED BAGS
Printed PVC and PET Sleeves
TAMPER EVIDENT LABELS AND SEALS
(Heat Shrinkable PREFORMS)
SHRINK WRAP FILM
Shrink Bands for CD Stacks
Infrared Heat Tunnels
The use of heat shrinkable polymer tubing has become the prevalent choice for the tamper evident packaging of food and pharmaceutical products. These shrinkable bands also provide a low cost packaging solution for multi packs and other products that are hard to process through standard wrapping equipment, or which have annual production volumes which do not warrant the purchase of dedicated equipment.
Also, full color printed sleeves provide the ability to label the product and provide the required tamper evidence in one operation.
Shrink wrapping is a technology now in it's fourth decade. While the applications have changed dramatically, most of the equipment used to process this type of material has not. The standard "hot air" equipment produced by many manufacturers provides less than optimum results as it was designed to shrink a fully over wrapped product whereby the film can "balloon" before it contacts the product to shrink evenly.
SPECIFICATIONS HEREBands and sleeves are open at both ends and contact the product quickly stopping further shrink because the product "sinks" heat away from the shrink polymer. Sleeves and tamper bands require a more concentrated and controlled application of heat.
Our line of shrink systems provide a state of the art solution to today's demanding applications. The proprietary infrared panel design allows for pin point control in the application of heat to the product for optimum shrinkage and uses far less energy than other heater designs. This is due to the construction of the radiant panels that project heat only towards the product and heat the band directly rather than air, much like heats the earth from 93 million miles away. Competitive infrared type systems have heating elements that radiate in all directions wasting most of the energy.
The unique abilities of infrared tunnels allow for difficult applications such as multipacks where band graphics along with UPC code must remain undistorted. Shields can be placed within the tunnel to block heat from certain areas that contain perforations or other areas that require less heat.
SPECIFICATIONS HEREProduction line lengths can also be reduced with the infrared systems to fit tight restrictions. Large diameter bands are also easily handled since there is no blowing air to dislocate the bands.
In addition to ongoing energy cost savings, the initial capital outlay for the IRHT systems is lower due to the open over conveyor design. This allows the system to be sized for the band rather than the entire product and provides the ability to run a wide range of sizes with equal efficiency.
1-800-759-9799
If you prefer a ServiPak packaging specialist to contact you, simply complete our
INFORMATION REPLY FORMemail: service@servipak.com
